|
Druck DPI 610 -1 to 2 Bar
DPI 610 / 615 Series
- Ranges 0 to 2.5 mbar through to 700 bar
- Accuracy 0.025% FS all ranges
- Intrinsically safe version
- RS 232 interface and fully documenting version
- Integral combined pressure/vacuum pump
- Dual readout! 4 to 20 mA loop test facility
The technically advanced Druck DPI 610 and DPI 615 portable calibrators
are the culmination of many years of field experience with the company’s
DPI 600 series. These self-contained, battery powered packages contain a
pressure generator, fine pressure control, device energising (not IS
version) and output measurement capabilities, as well as facilities for 4 to
20 mA loop testing and data storage.
The rugged weatherproof design is styled such that the pressure pump can
be operated and test leads connected without
 compromising
the visibility of the large dual parameter display. The mA step and ramp
outputs and a built-in continuity tester extend the capabilities to include
the commissioning and maintenance of control loops. Intrinsically Safe
versions are available as complete maintenance tools and portable
calibration standards for pressure instruments and control loops in
hazardous ’Zoned‘ areas. Certified to BASEEFA and CENELEC standards, the
DPI 610IS and DPI 615IS can reduce response times to breakdowns and
emergencies by removing the need for ’Hot Permits‘ and gas detection
equipment.
This gives peace of mind to all those responsible for safety within
hazardous areas. A highly accurate and easy to use calibrator is only part
of the solution for improving overall data quality and working efficiency.
The DPI 610 and DPI 615, with data storage and RS 232 interface, reduce
calibration times and eliminate data recording errors. The DPI 615 also
provides error analysis for field reporting of calibration errors and
pass/fail status. In addition, procedures downloaded from a PC automatically
configure the DPI 615 to pre-defined calibration and test routines.
| 
